Friday, February 12, 2016

How to make a PC detect a (DEAD) MTK device after flashing with wrong ROM/FIRMWARE (Test Point method)

How to get a PC detect a (DEAD) MTK device after flashing with wrong ROM/FIRMWARE (Test Point method)
It is always advisable to backup a device STOCK ROM/FIRMWARE that you are about to flash, and it is always wise to flash the preloader.bin file found inside a ROM folder except you are really sure that the preloader.bin is exactly the one for that device. Since we are humans we are bound to always make mistakes
If you made a mistake and flash a ROM with a preloader.bin file which is not the one of the device, the preloader partition gets corrupted thus making the device not being detected by the PC, boot or even charge ie Dead Boot. Since it cannot be detected, there is no way you can reflash the phone with the backed-up ROM or even when the original  ROM of the device is now available.
This post will show you how you can get your PC to be able to recognize and detect the device again if its in such situation. This process to repair dead boots of mtk devices is known as Test Point.

Disclaimer
Romshillzz is not responsible for what ever may happen to your device after using this procedure
Do this at your own risk!

Firstly, you will have to loose the screws of the phone and take out the board.
Then on the board, you will find golden or silver points with various labels like Tx, Rx, Vcc, KCOLO, COLO, KOLO, GND etc

Now locate a golden or silver point with lable KCOLO or KOLO or COLO on the board. Sometimes these points are found at the volume terminal.
Solder a wire on that point (KCOLO, KOLO or COLO)
Locate the golden or silver point with GND or normal ground on the board.
Join the wire form KCOLO or COLO or KOLO to GND on the board.
After joining this 2 points, try flashing the device with it's exact (good working & matching) Stock ROM/FIRMWARE, connect the device to the PC using USB Cord and see if it detects.
If it doesn't, look for another golden or silver point with same label till your device gets detected by PC.


When your device is detected by PC, it shows as MTK USB COM inside device manager.
Now you will have to quickly flash the original preloader.bin file or complete ROM.
After a successful flash process your device, you can now cut off the wire which you connected.
Couple back the phone & Reboot.

Points to note
Never use the Tx, Rx, Vcc or any other point that carry some amount of voltage
Phones with no (KCOLO,KOLO or COLO) on its board are mostly spd devices which rarely dies (DEAD MODE)


 TEST POINT METHOD


This Method is 100% tested by ME (RomShillzz)

If this method worked for you drop your comments!

Please if you have any other working test point of a device kindly send the images so I can share to help others

Wednesday, February 10, 2016

HOW TO UNBRICK TECNO N3 USING UNIVERSAL ANDROID AIO FLASHER


Download and install adb drivers from here
Extract the contents of the ROM.

Boot your device into fastboot mode
To do this, remove battery, hold volume - (down) button and connect the device to your computer,
Release the volume - button about 5 secs after the logo displays.

Launch Android AIO flasher.exe

Tick boot
Click select file (browse and select the boot.img file)
Tick erase

Wait  until you see "writting sys.yaffss2.img OK" before you know boot.img is flashed to the device
This process can take about 2 mins.

Now you have to flash sys,yaffs2.img file
Tick System
Click select file (browse and select the sys.yaffs2.img file)
Tick erase
Click flash


Wait until you see "writting sys.yaffs2.img OK" before you know boot.img is flashed to the device.
This process can take about 2 mins.

Disconnect device from computer.
While holding volume + (up) button connect the device back to the computer.
Keep holding volume until you enter the Android 3e stock recovery menu.
Using volume + & volume - key to move
Select "wipe cache" press Power button to select
Select "wipe data/factory reset"

Restart Phone!!

Saturday, February 06, 2016

DOWNLOAD ALL KIMFLY STOCK FIRMWARE'S


Firmwares (Stock ROMs) for restoring bricked Kimfly phones.
Flash these bin files using Miracle Box, Volcano Box, GPG Dragon or any other box

Learn how to flash Spreadtrum 8810/6820 Devices Using Miracle Box from here


Download Miracle Box Setup from here
Download UpgradeDownload Tool from here

Download Miracle Box Crack Version from here
Download Volcano Box Tool from here

Download GPG Box & Crack GPG Dragon Box Tool from here
Download Tools & Drivers Updates from here


DOWNLOAD ALL KIMFLY STOCK FIRMWARES

Kimfly A7
Chip: SPD 6531

Kimfly A8
Chip: SPD 6531
DOWNLOAD

Kimfly A12
Chip: SPD 6531
DOWNLOAD

Kimfly A14
Chip: SPD 6531
DOWNLOAD

Kimfly A17
Chip: SPD 6531
DOWNLOAD

Kimfly E1
DOWNLOAD

Kimfly E2
DOWNLOAD

Kimfly E3
DOWNLOAD

Kimfly E4
DOWNLOAD

Kimfly E5
DOWNLOAD

Kimfly E6-E7
DOWNLOAD

Kimfly E21-E29
DOWNLOAD

Kimfly E28
DOWNLOAD

Kimfly F5
Chip: SPD 6531
DOWNLOAD

Kimfly K1
DOWNLOAD

Kimfly K109
DOWNLOAD

Kimfly K5500
Chip: SPD 6531
DOWNLOAD

Kimfly T2000
Chip: SPD 6531
DOWNLOAD

Kimfly M1
DOWNLOAD

Kimfly M2
DOWNLOAD

Kimfly M3
DOWNLOAD

Kimfly M4
DOWNLOAD

Kimfly M5
DOWNLOAD

Kimfly M6
DOWNLOAD

Kimfly Z4
Chip: SPD 6820/8810
DOWNLOAD

Kimfly Z5
Chip: SPD 6820/8810
DOWNLOAD

Kimfly Z6
Chip: SPD 6820/8810
DOWNLOAD

Kimfly Z7
Chip: SPD 6820/8810
DOWNLOAD

Kimfly Z8
Chip: SPD 6820/8810
DOWNLOAD

Kimfly Z8 BACKUP
Chip: SPD 6820/8810
DOWNLOAD

Kimfly Z9 (.pac)
Chip: SPD 6820/8810
DOWNLOAD

Kimfly Z30 (.pac)
Chip: SPD 6820/8810
DOWNLOAD

Kimfly Z31 (.pac)
Chip: SPD 6820/8810
DOWNLOAD

Kimfly Z33 (.pac)
Chip: SPD 6820/8810
DOWNLOAD

Kimfly Z50-Z51
Chip: SPD 6820/8810
DOWNLOAD

Kimfly Z51 v1.7.1
Chip: SPD 6820/8810
DOWNLOAD

Kimfly Z51 v1.7.2
Chip: SPD 6820/8810
DOWNLOAD


Click here to redirected to my drive where you can download All KIMFLY Firmwares


Please leave a comment after using this ROMs
Report if you cannot download any of these files.



Quick Tips: How to flash Kimfly devices with bin file using Miracle Box

Note
Follow the instructions on how to flash this devices carefully from tips bellow
I will not take responsibility on whatever may happen to your device.

Make sure you are downloading the exact Firmware of the device you want to flash because
 flashing a wrong Firmware, will make the device completely dead
(can't power on, can't charge and will not be detected by a computer)



STEPS

Launch Miracle Box
Click on SPD
Tick Write
Under Choose type, Select the chip of the device you want to flash
Click the small yellow folder
Navigate to the ROM/Firmware folder and select the bin file
Click Start button
You will see Scanning USB Serial port...
Connect device to PC while holding boot key (volume up or volume down)
Miracle will detect the phone and start flashing process
When you see Done! Flashing process is complete
Disconnect and boot up phone




WARNING!
Flashing will erase all of your data
All described operations you are doing at your own risk.


Thursday, February 04, 2016

DOWNLOAD SNOKOR STOCK ROMS


Download Snokor Stock ROMs (Firmwares & pac files)

Download UpgradeDownload Tool from here

Learn how to backup Stock ROMs/FIRMWARES before flashing from here

Learn how to flash this devices using ResearchDownload/Upgrade Download tool from here

Learn how to flash SPD Android devices using Miracle Box from here

Learn how to flash/unbrick Spreadtrum feature Phones (Basic Phones) from here

Learn how to flash Spreadtrum 8810/6820 Devices Using Miracle Box from here

Learn how to write/repair imei (serial number) on spd devices using Miracle Box here

Learn how to write, repair or change imei (serial number) on spd devices using WriteIMEI Tool from here

Learn how to boot android devices into recovery mode using Miracle Box from here

'Ghost Push': An Un-Installable Android Virus Infecting 600,000+ Users Per Day Read more »


Note
Follow the instructions on how to flash the device carefully from the link above
I will not take responsibility on whatever may happen to your device.

Make sure you are downloading the exact Firmware of the device you want to flash because
 flashing a wrong Firmware, will make the device completely dead
(can't power on, can't charge and will not be detected by a computer)



SNOKOR ROCKET Z5000


Please leave a comment after using this ROMs
Report if you cannot download any of these files.


Tuesday, February 02, 2016

DOWNLOAD iTEL STOCK ROMS (.PAC FILES)


Download pac files (Stock ROMs) for iTel devices

Download UpgradeDownload Tool from here

Learn how to backup Stock ROMs/FIRMWARES before flashing from here

Learn how to flash this devices using ResearchDownload or Upgrade Download tool from here

Learn how to flash SPD Android devices using Miracle Box from here

Learn how to flash Spreadtrum 8810/6820 Devices Using Miracle Box from here

Learn how to write/repair imei (serial number) on spd devices using Miracle Box here

Learn how to write, repair or change imei (serial number) on spd devices using WriteIMEI Tool from here

Learn how to boot android devices into recovery mode using Miracle Box from here

'Ghost Push': An Un-Installable Android Virus Infecting 600,000+ Users Per Day Read more »


Note!
Most ROMs are pac files
If the ROM is not a pac file, Simply launch the ResearchDownload.exe inside the extracted folder, start and connect device.

ITEL FEATURE PHONES (BASIC PHONES)
Any donation to support this site is highly appreciated!

Enter Amount (₦)



Click here to make donations using U$D

Monday, February 01, 2016

DOWNLOAD MICROMAX STOCK FIRMWARE


Download Micromax Stock ROMs (firmwares)

Download SP Flashtool for mtk devices here

Learn how to use SP Flash Tool to flash/unbrick & upgrade mtk android devices here 

Learn how to write mtk devices imei (serial number) with Volcano Box here

NOTE

Follow the instructions on how to flash the device carefully from the link above

I will not take responsibility on whatever may happen to your device.

Make sure you are downloading the exact ROM of the device you want to flash because

 flashing a wrong preloader, will make the device completely dead

(can't power on, can't charge and will not be detected by a computer)



Please leave a comment after using this ROMs
Report if you cannot download any of these files.


Shop Now!

-----------------------------------------------------------------------------

https://goo.gl/xOQVz1

http://romshillzz.blogspot.com/2017/01/get-your-business-noticed-advertise-on.html

Shop Now!



What are you Looking for?

.

Featured post

Some tips to stop display errors after flashing SPD and MTK devices

I've been receiving lots and lots of complains about screen errors such as touch not working, blue/white/black screen, display is u...

Popular Posts

Recent Comments

RSS Feeds

Advert

COASTALZ DATA LINKZ
motto: "world of possibilities"

ENROLL YOUR CHILD TODAY ON HOW TO

FLASH,
UNLOCK,
UPGRADE,
ROOT
&
REPAIR
ALL KINDS OF PHONES.

WE ALSO SALE

>> FLASHING BOX
(miracle box, volcano box, gpg dragon box, cyclone box, infinity best dongle etc..)


>>
MOBILE PHONE ACCESSORIES
(screen, calibrator & batteries)

@ AFFORDABLE PRICE!

Address:
Shop no.3 beside Total Filling Station, Lafia Road Akwanga, Nasarawa State Nigeria.

For enquiries Contact : 07030392090
or
Contact RomShillzz @: 08100999057

Blog Archive

DONATE!

If this blog has helped you in any way, support this blog by donating for it's welfare.

Donation of any kind is acceptable!



WhatsApp +234 81 009 99057




DONATE!
MY NAIJA GUYS SHOW SOME LOVE BY SENDING RECHARGE CARDS [MTN & AIRTEL]

Enter Amount

Choose Currency

Bet Here ⬇

https://wlnairabet.adsrv.eacdn.com/C.ashx?btag=a_1580b_21c_&affid=1056315&siteid=1580&adid=21&c&MediaID=11&IsAd=1


NaijaBet ⬇
http://www.naijabet.com/banner/track/MTYyNjAxfDk0YjAwZTJlN2Q1NGM3MWQ3MjQzZjliNTI3NmMwYzk5/52/en_US

AdsOptimal

Monetize your web traffic on mobile today.
Earn highest revenues for your mobile web.